How do I clean the filter on my Kenmore 500 washer?

Remove the agitator from your Kenmore washer, which is the barbell-shaped object inside the machine’s drum. Dispose of any built-up debris and then dry-scrub the surface with a dust cloth, cleaning it with dish soap if there are food particles or coffee grounds stuck to it; dry thoroughly.

Insert metal ring onto plastic lint trap and thread into place on agitator; tightly to reassemble.

Where is filter on Kenmore washer?

Disconnect the water line between the filter and pump. Place a bowl underneath to catch any drips. Loosen the screws on the filter housing, using an adjustable wrench. Take out the old filter and discard it. 

In your new one securely hold it with fishing pliers while careful not to cross-thread the connections. Put everything back together in reverse order.

To locate the filter assembly, pry open the front cover using a flat blade screwdriver. Unplug the drain hose from beside the filter and drain water into a bucket. Then unscrew the pump filter using a hand and replace it with the new one.

To locate the pump filter assembly, unscrew the small door on the front of the washer just enough to insert a flat-blade screwdriver and pry it out. Kenmore series 500 washer.

After you do this, unplug the drain hose near the filter assembly and drain the water into a bucket. Then unscrew or unclip your current pump filter and replace it with your new one.

Do top load washers have filters?

Top load washers and standard top load washers usually require removing the outer housing of the appliance to access the pump filter at the back of the machine.

This pump filter is essential for water flow but must be cleaned regularly as lint and other debris can clog it. Regular cleaning will ensure optimal water flow which will help prevent lint from sticking to your clothes.

Top-load washing machines and front-loading washing machines usually require that the outer housing is removed to access the water pump filter on the back of the machine. …

Cleaning this pump filter regularly will help water flow more quickly, taking suspended lint with it and not leaving it to redeposit on your clothes.

Top-loaders and standard-top load washers have a water pump filter at the back. Check out the illustrations to learn how to clean it well … this will ensure that all your clothes have plenty of water so they don’t tang up in lint!

How do you clean the rubber seal on a front load washer?

Standing inside the washer, remove the gasket so you can get a better view of the interior. You should be able to spot any unwanted or potentially harmful objects which have slipped in unnoticed, including hair, buttons, coins and anything else you can see.

Spray some hot water mixed with mild soap directly into the drum while scrubbing at any dirt or mildew that appears on top of it using a wet rag. Repeat this process if necessary. Source

Open the washer door and peel back the gasket so you can see inside. Remove any visible objects inside, like hair, buttons or coins. Spray hot, soapy water into the detergent dispenser to clean out mildew. Wipe it clean with a clean cloth. Repeat as needed.

Remove the washer door, and open the interior so you can see where cleaning is needed under the rubber gasket. Clean hair and other visible objects off of it. Spray hot, soapy water and wipe with a clean cloth to remove mildew.